Understanding the result
The live viola tuner detects real-time microphone input and evaluates your pitch against standard orchestral viola tuning (C3 G3 D4 A4) at international concert pitch (A4 = 440 Hz). The interface displays nominal frequency, live measured note, and cent deviation (-50 to +50 cents), indicating whether your bow stroke or plucked note is flat, sharp, or in tune within ±4 cents.
How to use this tool
- Choose C3, G3, D4 or A4.
- Bow or pluck the selected string.
- Adjust until the reading approaches zero cents.
Standard Viola Tuning: C3 G3 D4 A4 in Perfect Fifths
The viola is tuned in descending perfect fifths: 1st String (A4 = 440.00 Hz), 2nd String (D4 ≈ 293.66 Hz), 3rd String (G3 ≈ 196.00 Hz), and 4th String (C3 ≈ 130.81 Hz). Standard practice numbers strings from the highest pitch (A string on the right side of the fingerboard looking down) to the lowest pitch (C string on the left side). This tuning gives the viola its distinct, warm, alto-tenor orchestral voice.
Viola vs. Violin vs. Cello Pitch Ranges Compared
Understanding where the viola sits in the string family clarifies string targets: A violin is tuned G3 D4 A4 E5 (one fifth higher, featuring a bright high E string but no C string). A cello is tuned C2 G2 D3 A3 (the exact same letter notes as the viola, but sounding one full octave lower). The viola is the only orchestral string instrument whose open pitch range spans the rich octave-3 and octave-4 registers between cello and violin.
Tuning with Fine Tuners vs. Pegbox Friction Pegs
Most modern student and professional violas feature fine tuners on the tailpiece (either built into an integrated tailpiece or mounted on individual string adjusters). Use the traditional wooden friction pegs in the pegbox for major pitch adjustments when a string is more than 30–50 cents flat or sharp, pushing inward gently while turning to seat the peg taper in the pegbox hole. Use the tailpiece fine tuners for micro-adjustments to center the needle at zero cents.
Bowing (Arco) vs. Plucking (Pizzicato) for Browser Pitch Detection
For the most consistent and reliable tuner reading, draw a clean, steady, mezzo-forte bow stroke across the string halfway between the bridge and fingerboard. Maintain consistent bow speed and light-to-moderate arm weight; pressing too heavily onto the string bends pitch sharp, while bowing too lightly creates airy surface noise. If tuning silently or pizzicato, pluck firmly near the end of the fingerboard and allow the string to ring.
Capturing the Deep Fundamental of the Low C String (C3, 130.81 Hz)
The viola's lowest string (C3) produces rich, deep fundamentals that can challenge small phone and laptop microphones. Built-in device mics often roll off low frequencies and emphasize high harmonic overtones, causing pitch detectors to momentarily display C4 or G3 instead of C3. To ensure stable C3 detection, hold the viola within 8 to 12 inches of your microphone, bow with an even, full bow stroke, and let the note settle for two seconds.
Tuning by Open Fifths and Acoustic Overtones
In chamber music and orchestral settings, violists often establish the open A string with an electronic tuner or concert pitch reference, and then tune D, G, and C by ear using double-stop fifths (listening for beating until the pure fifth rings harmoniously). While our browser tuner allows beginners to check each string individually against equal-tempered targets, intermediate players can use it to verify their just-intonation fifths.
Troubleshooting
- Friction pegs slip or unwind suddenly: Wooden viola pegs rely on friction within the pegbox. Push firmly inward toward the pegbox while turning the peg clockwise to seat the wood taper securely.
- Tuner needle wavers while bowing: Uneven bow speed or variable arm pressure causes pitch to fluctuate. Use a long, relaxed, steady bow stroke at a consistent contact point.
- Low C string detected an octave higher (C4 instead of C3): Device microphones roll off low frequencies, letting the 2nd harmonic dominate. Move closer to your microphone, bow slower, and use a warmer contact point toward the fingerboard.
- Tailpiece fine tuner screw is screwed all the way down: Loosen the fine tuner screw almost completely, then use the pegbox friction peg to bring the string back to approximate pitch, and finish fine-tuning.
- Adjacent strings ring and confuse the detector: Ensure your bow hair touches only the intended single string without grazing neighboring strings.
Browser and device limitations
The browser viola tuner processes monophonic audio streams using Web Audio API YIN autocorrelation. It cannot assess instrument setup, bridge arching, soundpost alignment, or string core wear.